New problem, mid cut, its like the power goes out, and comes back on. Machine restarts goes to the start screen, and I have to restart the cut.
Never seen this one before. Not sure if it’s a time issue, a heat issue, a short, no clue. Didn’t do it on my last cut, did it the cut before, did it this cut.
Any ideas on why the computer would just power cycle?
What should I check?
Same here! Just happened.
There are kill switches behind the baffle in the back of the tank that will kill the machine if the water level gets too low or too high. When it power cycles like that, it’s probably one of the kill switches that reached its threshold and bobbed back up to turn the machine back on. Clean out your baffle and clean the switches off with some fresh water. If the baffle gets too clogged, the water in the tank will not make it back behind the baffle and the water level back there might get too high or low.
If that doesn’t work, reach out to the customer support team, they’re pretty great and should get you back on your feet in a couple minutes