Had been running flawlessly with a small cutting project.
Inserted the SD card with a new project, but it refused to do a "dry run.
"
Ok - I just started it anyway and pressed “Start.”
A loud click came from the right side of the Wazer.
Now it can do NOTHING - completely dead. There is not even a light in the display.
Total hours so far on the machine 4 hours 49 minutes.
Any suggestions?
I am embarrassed.
The water level was ok, but the emergency stop was pressed all the way down.
It still can’t do a “Dry Run.”
When I try to start a new job and press Start, there is just a loud click from the right side of the Wazer, and nothing happens.
The display says “Cut completed”
Total time 00:00:00
Something is clearly not working.
The Wazer is running fine.
The biggest problem is the user of the machine
If it won’t run a “dry run,” there is something wrong with your G-code.
Btw. The SVG format is way easier to use than DXF.
