Cutting ACM Material?

Hi, I was wondering if anyone has cut ACM on their Wazer yet? If so, would the material settings in Wam be the same as the Aluminum ones, or how would you calculate them? Thanks so much!

@counterfitters Curious how this turned out for you. What were the results like?

If you haven’t cut this yet, my opinion was going to be just go with the thickness as if it was all aluminum. So if it’s 1/8" thick, just use that setting for the material. Maybe start at the medium setting since it’s not solid Al.

@Aaron.MECHA I did wind up setting it as if it was solid aluminum, and the cut worked great :slight_smile:

1 Like