Wazer Desktop: Kerf reduction?

1

I am considering the Desktop unit to cut gasket material (Durlon HT1000), which is basically phlogopite mica paper and some binder.

I know the specs call for a 1.1mm kerf.

Is there a way (even with some modification) to get to a lower value?

The material I am trying to cut is only 1/64 in thick.

I am trying to cut very small holes (0.5 mm nominal) in the gaskets.

Thanks

2

Not likely. The kerf is basically the width of the waterjet stream, can’t get any smaller than that.