# Started cut with water off
**URL:** https://community.wazer.com/t/started-cut-with-water-off/688
**Category:** Help & Support
**Created:** [March 25, 2023, 2:06am UTC](https://community.wazer.com/t/started-cut-with-water-off/688 "2023-03-25T02:06:14Z")
**Posts on this page:** 4
**Page:** 1
### Author:  [@bobbyzalryte](https://community.wazer.com/u/bobbyzalryte)
#### Post date: [March 25, 2023, 2:06am UTC](https://community.wazer.com/t/started-cut-with-water-off/688/1 "2023-03-25T02:06:15Z")
Is there a procedure to follow after trying to run a cut with the water off? I started a cut noticed the sound was different and the water was not connected to the faucet. I hit the emergency shut off. When I tried to start again the pump didn’t sound right so I stopped it and tried priming the high pressure system. The stream doesn’t go clear and water pours out of the abrasive tube input when I check the HP valve. Any suggestions? I would really like to get back to work this weekend rather than wait to hear from support Monday! Thanks.
---
### Author:  [@Fablab\_Descartes](https://community.wazer.com/u/Fablab_Descartes)
#### Post date: [July 30, 2024, 3:39pm UTC](https://community.wazer.com/t/started-cut-with-water-off/688/2 "2024-07-30T15:39:13Z")
Hi, I am facing the same situation. Did you get any answer from support, or find a solution to this problem ? Thanks.
---
### Author:  [@bobbyzalryte](https://community.wazer.com/u/bobbyzalryte)
#### Post date: [July 30, 2024, 6:19pm UTC](https://community.wazer.com/t/started-cut-with-water-off/688/3 "2024-07-30T18:19:59Z")
Sorry, I don’t remember how I resolved the problem. I think I ended up replacing the orifice.
---
### Author:  [@Fablab\_Descartes](https://community.wazer.com/u/Fablab_Descartes)
#### Post date: [July 31, 2024, 7:00am UTC](https://community.wazer.com/t/started-cut-with-water-off/688/4 "2024-07-31T07:00:16Z")
ok, thanks, I’ll look into it.