# New Abrasive Troubles

**URL:** <https://community.wazer.com/t/new-abrasive-troubles/2157>\
**Category:** General Discussion\
**Created:** [September 22, 2026, 11:34pm UTC](https://community.wazer.com/t/new-abrasive-troubles/2157 "2026-09-22T23:34:53Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![TheGlassThumb](https://yyz1.discourse-cdn.com/flex027/user_avatar/community.wazer.com/theglassthumb/32/1044_2.png) [@TheGlassThumb](https://community.wazer.com/u/TheGlassThumb)\
**Post date:** [September 22, 2026, 11:34pm UTC](https://community.wazer.com/t/new-abrasive-troubles/2157/1 "2026-09-22T23:34:53Z")

</div>

Has anyone else noticed a difference in usage and performance since the abrasive was changed? I ask, because I am not sure if there is an issue somewhere, or this abrasive acts differently and I should be adjusting a setting. I cut glass only and have been going through one bag per 12x12 sheet. Not a ton of pieces cut either. We also already updated the wazer to accommodate this new abrasive. So, everything should be in working order to handle it. I am wondering if there is just something in the set up I am missing and clicking through. Thanks to anyone that has insight! 🙂 You all know, abrasive is not something you want to go through quickly!

---

<div class="post-metadata">

**Author:** ![jimandem](https://avatars.discourse-cdn.com/v4/letter/j/7c8e57/32.png) [@jimandem](https://community.wazer.com/u/jimandem)\
**Post date:** [October 4, 2026, 10:13am UTC](https://community.wazer.com/t/new-abrasive-troubles/2157/2 "2026-10-04T10:13:24Z")

</div>

Is this a table top or Pro? That is alot of abrasive. Didn’t know it changed. If it’s a pro we us a 1 sec piercie time and it works well on 3mm.

---

<div class="post-metadata">

**Author:** ![Ksmilner](https://avatars.discourse-cdn.com/v4/letter/k/6a8cbe/32.png) [@Ksmilner](https://community.wazer.com/u/Ksmilner)\
**Post date:** [October 6, 2026, 3:00pm UTC](https://community.wazer.com/t/new-abrasive-troubles/2157/3 "2026-10-06T15:00:36Z")

</div>

Have you checked the abrasive flow rate?
