# Limits of machine detected

**URL:** <https://community.wazer.com/t/limits-of-machine-detected/896>\
**Category:** Help & Support\
**Created:** [January 29, 2024, 9:10pm UTC](https://community.wazer.com/t/limits-of-machine-detected/896 "2024-01-29T21:10:00Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![greisinb](https://avatars.discourse-cdn.com/v4/letter/g/b9e5f3/32.png) [@greisinb](https://community.wazer.com/u/greisinb)\
**Post date:** [January 29, 2024, 9:10pm UTC](https://community.wazer.com/t/limits-of-machine-detected/896/1 "2024-01-29T21:10:00Z")

</div>

My WAZER homes normally, but when I go to run a tank cleaning cycle I get the “Limits of Machine Detected” error message when the nozzle is in the back left hand corner. Presumably the Y minimum switch is working as it should (because it homes properly) but could this error be encountered if the X max switch is not being triggered? Not being able to clean the machine regularly is frustrating.

---

<div class="post-metadata">

**Author:** ![mellis](https://yyz1.discourse-cdn.com/flex027/user_avatar/community.wazer.com/mellis/32/977_2.png) [@mellis](https://community.wazer.com/u/mellis)\
**Post date:** [December 28, 2025, 11:13pm UTC](https://community.wazer.com/t/limits-of-machine-detected/896/2 "2025-12-28T23:13:50Z")

</div>

Did you ever figure out why this was happening? Something similar is happening with my machine now during a tank cleaning cycle. It gets close to the back left hand corner and then sputters a bit, then moves all the way to the right and I get the “Limits of Machine Detected Error.”

---

<div class="post-metadata">

**Author:** ![Tal](https://avatars.discourse-cdn.com/v4/letter/t/54ee81/32.png) [@Tal](https://community.wazer.com/u/Tal)\
**Post date:** [July 20, 2026, 1:30pm UTC](https://community.wazer.com/t/limits-of-machine-detected/896/3 "2026-07-20T13:30:49Z")

</div>

it’s happening to me as well.

did you find a solution?