# Cutting cement board

**URL:** <https://community.wazer.com/t/cutting-cement-board/2007>\
**Category:** General Discussion\
**Created:** [July 18, 2025, 2:26pm UTC](https://community.wazer.com/t/cutting-cement-board/2007 "2025-07-18T14:26:06Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![fairlynumm](https://avatars.discourse-cdn.com/v4/letter/f/c4cdca/32.png) [@fairlynumm](https://community.wazer.com/u/fairlynumm)\
**Post date:** [July 18, 2025, 2:26pm UTC](https://community.wazer.com/t/cutting-cement-board/2007/1 "2025-07-18T14:26:06Z")

</div>

Hi everyone - I’m new to the Wazer and getting started with some projects for a mosaic. I use Hardie cement backer board that is 1/4" thick and I don’t see that material listed anywhere. Can I cut it in the Wazer? And if so, what material setting would I use in WAM? Thanks in advance to anyone that might have some advice.

---

<div class="post-metadata">

**Author:** ![RandyW](https://avatars.discourse-cdn.com/v4/letter/r/a5b964/32.png) [@RandyW](https://community.wazer.com/u/RandyW)\
**Post date:** [July 19, 2025, 11:25am UTC](https://community.wazer.com/t/cutting-cement-board/2007/2 "2025-07-19T11:25:12Z")

</div>

As far as can it cut it. Yes. Should it be used to cut it? I wouldn’t. I would expect the cement to clog every pipe, pump and filter in the machine. Also I would not expect the quality of the cut would be very poor.

---

<div class="post-metadata">

**Author:** ![fairlynumm](https://avatars.discourse-cdn.com/v4/letter/f/c4cdca/32.png) [@fairlynumm](https://community.wazer.com/u/fairlynumm)\
**Post date:** [July 19, 2025, 1:27pm UTC](https://community.wazer.com/t/cutting-cement-board/2007/3 "2025-07-19T13:27:41Z")

</div>

Thanks Randy, I appreciate the response.